header.jpg

HOME   ABOUT US   REVIEWS   CONTACT   TEXTURES   PRO DRYWALL TIPS

 

 

HOW TO HAND COAT INSIDE DRYWALL ANGLES

 

The biggest mistake a rookie will make is trying to coat both sides of the angle on the same coat (same day).

The problem here is that once you get one side pretty and you try to coat the other side, you mess up the 1st side.

The trick is 1st side one day, 2nd side next day.

 

I'll show you step by step how to do it.

This step you would do day after you tape your job.

To learn about how to hand tape go here How to hand tape drywall

 

STEP 1: Mix Mud, Spread

 

Mix up your joint compound (With water) until it is thin enough to work with. This is important, mud right out of the bucket is way too thick for anything. For more on mud and how to mix go here

All about Joint Compound

Using a drywall pan and a 6" knife, spread a nice even bed of mud on one side of the angle. Try to go from the ceiling down about half way.

 

 

 

 

STEP 2: Feather In Outside edge

 

Place your pointer finger a little to the left of center. As you pull the knife down the corner, apply a lot of pressure on the outside edge (See Picture) See the ripple line , that's what you want. Once you have feathered in the outside edge,

 

Final Swipe

Put your finger back on the center of the knife and wipe down the angle again, this time using firm even pressure on the middle of the knife.

 

 

STEP 3: Clean Edge

 

See how you get a little edge of mud there (See Picture). Just pull it to the right.

 

 

 

STEP 4: Repeat The Same Procedure On The Bottom Half Of The Angle

 

 Spread On Mud

Start about an inch from the floor and spread on a nice bed of mud all the way up until you meet the upper section you just coated

Feather In Outside edge

Same as above, Pointer finger applying pressure to the outside edge of the knife. Try to leave a nice ripple all the way up the Angle

 

Final Swipe

Put your finger back on the center of the knife and wipe up the angle again, this time using firm even pressure on the middle of the knife. When you reach the upper section (that we just coated) stop!! You should only leave one little lap mark where the 2 sections meet.

 

Clean Edge, that's it...

 

One side of your angle should be coated from the floor to the ceiling.

Let the angle dry over night, Give it a quick little sand job and coat the other side tomorrow (Using the same exact procedure).

This was just example of how to do it. You could be doing a ceiling angle just as easily. Just remember one side per day.

 

This is how the pro's do it.

This is called an angle box. It coats both sides of the angle SAME DAY

 

  

© 1999-2022  Belldrywall.Com , All Rights Reserved.